PortaBrew - Instruction Manual

INSTRUCTION MANUAL

(Caution: Do not submerge or wash the main unit. Wipe with a damp cloth only to avoid damaging the electronic components)

Charging

  1. Please charge the device when the red LED is on. There are options for USB cable, car charger cable, and adapter. The red LED will remain on while charging, and the green LED will turn on once fully charged.
  2. The device can work directly when connected to an adapter or car charger cable. However, when using a USB cable for charging, it cannot operate until fully charged.

Cautions

  1. Do not touch the red pad on the cap while the device is heating. Keep children away from the device when it is heating.
  2. Do not heat the device if there is no water inside, even though there is anti-dry heat protection up to 145°C. When anti-dry heat protection is activated, the LED will flash for 5 seconds and beep for 5 seconds.
  3. Clean the device and keep it dry after use.

LED Color and Working Status

  • Red LED flashes for 5 seconds: Heat overtime
  • Orange LED is on: Heating
  • Green LED is on: Extraction

Troubleshooting

Malfunction Analysis Troubleshooting
Red light is on for 8 seconds Ran out of battery Charge it for 3 to 5 hours to ensure a full recharge.
Red light flashes slowly with buzzer sound for 5 seconds Heat time exceeded 15 minutes, device stopped working Restart the device. Double-click the power button to heat water.
Red light flashes quickly with buzzer sound for 5 seconds Overheating protection Remove the cap and allow the device to cool for 5 minutes. Then reheat by double-clicking the power button.

Capsule Usage

Big Capsule

  1. Insert the big capsule into the capsule holder.
  2. Screw the capsule holder tightly onto the main unit. Failure to secure it tightly may result in extraction failure or water leakage.
  3. Buckle the cup onto the machine.

Small Capsule

  1. Insert the small capsule into the small capsule holder.
  2. Place the small capsule holder into the big capsule holder.
  3. Screw the big capsule holder tightly onto the main unit. Failure to secure it tightly may result in extraction failure or water leakage.
  4. Buckle the cup onto the machine.

Coffee Powder

  1. Add coffee powder into the coffee powder holder and place the lid on.
  2. Insert the coffee powder holder into the big capsule holder.
  3. Screw the big capsule holder tightly onto the main unit.
  4. Buckle the cup onto the machine.

Coffee Extraction

Cold Water Extraction

  1. Remove the cap, pour cold water into the water container, and close the cap.
  2. Press the power button once to check the battery level (green LED on). Then, long press the power button to begin cold coffee extraction (green LED flashing). The red LED will flash when the battery level is below 25%.
  3. To heat the cold water, press the power button twice. The water will heat to 86°C within 7 minutes (orange LED flashing), beep 4 times, and automatically extract hot coffee within 60 seconds (green LED flashing).

Hot Water Extraction

  1. Remove the cap, pour hot water into the water container, and close the cap.
  2. Press the power button once to check the battery level (green LED on). Then, long press the power button to begin hot coffee extraction (green LED flashing).